Smeg DF6SPLUS Manual de instrucciones descargar pdf (Pagina 34)

User instructions

6. Troubleshooting

The dishwasher is equipped with a self-diagnostics system that is

capable of detecting and signalling a number of possible faults.

TABLE OF FAULTS DETECTED BY THE SELF-DIAGNOSTICS SYSTEM

FAULT DESCRIPTION

E1 The anti-flooding system (where present) has been tripped service.

E2 The water level limitation system has tripped.

E3 The appliance cannot heat the water.

E4 The temperature sensor is disconnected.

E5 The appliance cannot take in the water.

E6 The appliance cannot drain the water from the tank.

The dishwasher cannot measure the precise water quantity that has

been loaded.

E8 Problem on the water distribution system to the baskes.

E9 Water intake system malfunction.

• The E1, E2, E3, E4, E8, E9 alarms provoke the “forcing” to end

cycle of the running program.

• The E5, E6 alarms interrupts the running program once the cause is

resolved, it will bring bach the execution of the program.

• The alarm E7 is visualized at the end of the cycle that comes,

however, brought to the end since the operation of the dishwasher is

not harmed.

To “reset” an alarm is necessary:

• Open and close the door, or turn off and on the machine. At this

point is possible to program the dishwasher again.

If the fault persists, call the authorised Technical Service Centre.

1 2 ... 29 30 31 32 33 34 35 36

Sin comentarios

Smeg DF6SPLUS Manual de instrucciones Pagina 34