Contents 1. INSTRUCTIONS FOR SAFE AND PROPER USE________________ 4 2. POSITIONING OF HOB ____________________________________ 6 3. GAS CONNECTION_
Instructions for the installer 12 4. ELECTRICAL CONNECTION Make sure that the voltage and capacity of the power line conform to the data shown on
Instructions for the installer 13 5. ADAPTATION TO DIFFERENT TYPES OF GAS Before performing any cleaning or maintenance work, detach the appl
Instructions for the installer 14 5.2 Regulation for LPG Loosen screw A and push support B all the way. Use a double head wrench to remove nozzle C
Instructions for the installer 15 5.3 Regulation for natural gas The hob has been adjusted for natural gas at a pressure of 1.0kPa. To allow the un
Instructions for the installer 16 6. FINAL OPERATIONS Having carried out the above adjustments, reassemble the appliance following, backwards, the
Instructions for the user 17 7. USING THE HOB Before turning on the burners, make sure that the burner rings, caps and grids have been fitted
Instructions for the user 18 7.2 Practical advice for using the burners For better burner performance and minimum gas consumption, flat bottomed, ev
Instructions for the user 19 8. LEANING AND MAINTENANCE Before any intervention, disconnect the power supply of the device. 8.1 Cleaning
Instructions for the user 20 8.2.1 Ignition plugs and safety devices For good functioning of the lighting ignition plugs and the safety devices, ke
Introduction 1. INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY
914773030/ B
Introduction THE IDENTIFICATION PLATE, WITH TECHNICAL DATA, SERIAL NUMBER AND MARKING IS CLEARLY VISIBLE UNDER THE CASING. THE PLATE ON THE CASING
Instructions for the installer 6 2. POSITIONING OF HOB The following operation requires building and/or carpentry work so must be carried out
Instructions for the installer 7 Overall dimensions: location of gas and electrical connection points (all measures in mm). A 100 B 350 C 60 D 6
Instructions for the installer 8 2.2 Clearance above and around domestic appliances Extract from AS5601 REQUIREMENTS 1 Overhead clearances – (
Instructions for the installer 9 2 Side clearances – (Measurements B & C) Where B, measured from the periphery of the nearest burner to any ve
Instructions for the installer 10 2.3 Room ventilation Caution – This hob may only be installed and operated in rooms permanently ventilated in a
Instructions for the installer 11 3. GAS CONNECTION This appliance is suitable for installation with Natural Gas or ULPG (propane). Refer to page
Comentarios a estos manuales