Smeg STFABUWH Manual de instalación

Contents1 INTRODUCTION ...32 SAFETY INFORMATION ...

82 cm - 87 cm32-9/32"; 34-1/4"59.7 cm - 59.9 cm23-1/2"; 23-37/64"58.5 cm23-1/32"(See fig.4-01)

4 DIMENSIONS OF DISHWASHER (See fi g. 4-01)ABCFig. 4-01A (height) B (width) C (depth)82 cm - 89 cm32-9/32” - 35-3/64”59.7 cm ÷ 59,9 cm23-1/2” ÷ 23-37/

5.1 Leveling 5.1.2 Levelling the applianceLevel the appliance using the relative adjustable feet (e.g.: ref. A fi g. 5-01); use an open-ended wrenc

• If the appliance is not in a niche and can therefore be accessed on oneside, cover the door hinge area for safety reasons (cutting haz

eh t s sap o t de r i uqe r s i ) ” 23 / 5 ( mc 8 t sae l t a f o r e t ema i d a h t i w e l oh hguo r h t A hoses and power cord (r

eh t s sap o t de r i uqe r s i ) ” 23 / 5 ( mc 8 t sae l t a f o r e t ema i d a h t i w e l oh hguo r h t A hoses and power cord (r

Do not cut the inlet hose (see fi g. 5-06).If the hose is cut, the dishwasher will not work, water will leak and you may be injured.If the hose is too

Do not cut the inlet hose (see fi g. 5-06).If the hose is cut, the dishwasher will not work, water will leak and you may be injured.If the hose is too

Connecting to a “T” union of the drain circuitMAKE THE CONNECTION UPLINE FROM THE SIPHON OF THE DRAIN LINE AND AT LEAST 400 mm (15-3/4”) ABOVE THE F

Connecting to a “T” union of the drain circuitMAKE THE CONNECTION UPLINE FROM THE SIPHON OF THE DRAIN LINE AND AT LEAST 400 mm (15-3/4”) ABOVE THE F

NO I T CUDOR T N I1Thank you for choosing one of our products. To install this dish-washer correctly and safely, please read this manual carefully. Th

Connecting to the air gap (no waste disposal unit)MAKE THE CONNECTION UPLINE FROM THE SIPHON OF THE DRAIN LINE AND AT LEAST 400 mm (15-3/4”) ABOVE T

Connecting to the air gap (no waste disposal unit)MAKE THE CONNECTION UPLINE FROM THE SIPHON OF THE DRAIN LINE AND AT LEAST 400 mm (15-3/4”) ABOVE T

sgn i n r aw dna sno i t cennoc l ac i r t ce l E 2 . 2 . 5 EHT FO YCNEUQER F EHT DNA EGA T LOV EHT T AHT KCEHC MAINS MATCH THE RATING

sgn i n r aw dna sno i t cennoc l ac i r t ce l E 2 . 2 . 5 EHT FO YCNEUQER F EHT DNA EGA T LOV EHT T AHT KCEHC MAINS MATCH THE RATING

Fig. 5-16Fig. 5-17

Before securing the dishwasher to the adjacent units, attach the gaskets to the sides.Remove the adhesive band on the gasket (see fi g. 5-18).Fix the g

Fig. 5-21 shows the state of the dishwasher after the above operations are performed.Tighten the supplied screws with a screwdriver; this operation de

5.4 TestingAfter installation, test the dishwasher by starting a work cycle. Check for leaks and make sure the appliance does not malfunction.Fig. 5-

EN28

NO I T CUDOR T N I1Thank you for choosing one of our products. To install this dish-washer correctly and safely, please read this manual carefully. Th

Symbols used in this manual (see tab. 1-01) DANGER. This symbol highlights information and warnings which, if not observed, may compromise person

Symbols used in this manual (see tab. 1-01) DANGER. This symbol highlights information and warnings which, if not observed, may compromise person

 FO NO I TCE TORP DNA YCNEUQERF , EGA T LOV EHT T AHT KCEHC THE DOMESTIC MAINS POWER SUPPLY MATCH THE RATINGS ON THE NAME PLATE OF THE APP

 FO NO I TCE TORP DNA YCNEUQERF , EGA T LOV EHT T AHT KCEHC THE DOMESTIC MAINS POWER SUPPLY MATCH THE RATINGS ON THE NAME PLATE OF THE APP

3 INSTALLATION MATERIAL:der i uqer era s l a i retam gniwol lof eht , y l tcer roc rehsawhs id eht l l atsn i oT ; )10-3 .g fi A . fer ( rev i

3.1 Kit supplied with dishwasherThe kit supplied with the dishwasher comprises:• 1 adhesive steam guard (depending on the model) (ref. A fi g. 3-02);•