Smeg UKU3C080P Manual de usuario descargar pdf (Pagina 11)

Problem Possible cause Solution

Food products prevent that

water flows into the water

collector.

Make sure that food prod-

ucts do not touch the rear

plate.

Water flows on the floor. The melting water outlet is

not connected to the evapo-

rative tray above the com-

pressor.

Attach the melting water out-

let to the evaporative tray.

The temperature in the appli-

ance is too low/too high.

The temperature regulator is

not set correctly.

Set a higher/lower tempera-

ture.

The door is not closed cor-

rectly.

Refer to "Closing the door".

The food products' tempera-

ture is too high.

Let the food products tem-

perature decrease to room

temperature before storage.

Many food products are stor-

ed at the same time.

Store less food products at

the same time.

The thickness of the frost is

greater than 4-5 mm.

Defrost the appliance.

The door has been opened

often.

Open the door only if neces-

sary.

If the advice does not lead to

the desired result, call the

nearest Authorized Service

Centre.

Replacing the lamp

Disconnect the plug from the mains socket.

1. Remove the screw from the lamp cover.

2. Remove the lamp cover (refer to the

illustration).

3. Replace the used lamp with a new lamp

of the same power and specifically

designed for household appliances (the

maximum power is shown on the lamp

cover).

4. Install the lamp cover.

5. Tighten the screw to the lamp cover.

6. Connect the plug to the mains socket.

7. Open the door.

Make sure that the light comes on.

Closing the door

1. Clean the door gaskets.

2.

If necessary, adjust the door. Refer to

"Installation".

3.

If necessary, replace the defective door

gaskets. Contact the Authorised

Service Centre.

11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios