Smeg FAB28UNER Manual de instrucciones Pagina 7
- Pagina / 20
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Instructions for the User
9
3.4 Electrical requirements
WARNING
Electrical Shock Hazard
Plug into a grounded 3-prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical
shock.
NOTE: Before you move your refrigerator into its final location, it is important to make sure you have the
proper electrical connection.
• Before switching the refrigerator on for the first time, leave it vertical for at least two hours. Then
connect the appliance's power supply lead to a main socket with earth contact, installed in
accordance with electrical safety regulations. The rated voltage and frequency are stated on the
nameplate inside the refrigerator compartment.
• The appliance must be connected to the electrical mains and earthed in compliance with the relevant
regulations and requirements. The appliance is able to withstand short fluctuations in voltage of no
more than 15% less or 10% more than the rated voltage stated on the nameplate.
• If the power supply lead has to be replaced, this operation must only be carried out by an authorised
technical service engineer.
• The socket must be accessible after the appliance has been placed.
3.4.1 Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15- or 20-amp fused, grounded electrical supply is required. It is
recommended that a separate circuit serving only your refrigerator be provided. Use an outlet that
cannot be turned off by a switch. Do not use an extension cord.
NOTE: Before performing any type of installation, cleaning, or removing a light bulb, turn the control
(Thermostat, Refrigerator or Freezer Control depending on the model) on position 0 (STOP) and then
disconnect the refrigerator from the electrical source. When you are finished, reconnect the refrigerator
to the electrical source and reset the control (Thermostat, Refrigerator or Freezer Control depending on
the model) to the desired setting.
Relacionado con productos y manuales para Neveras Smeg FAB28UNER
Neveras Smeg FAB28UVEL Boletín
(20 paginas)
(20 paginas)
Neveras Smeg FAB28UBEL1 Boletín
(2 paginas)
(2 paginas)
Neveras Smeg FAB32UPGLN Boletín
(1 paginas)
(1 paginas)
Neveras Smeg FAB28UITL1 Boletín
(2 paginas)
(2 paginas)
ACU-RITE 2035 manuels
Manuels d'utilisation et guides de l'utilisateur pour Non ACU-RITE 2035.
Nous fournissons des manuels en pdf 1 ACU-RITE 2035 à télécharger gratuitement par type de document : Manuel de l'utilisateur
Comentarios a estos manuales