Smeg APL360XC1 Manual de instrucciones descargar pdf (Pagina 26)

Instructions for the Installer

12.2 Positioning the oven

The appliance is designed for building-in to cabinets made from any heat-

resistant material. Comply with the dimensions shown in figures 1, 2, and

3. When installing under worktops, comply with the dimensions shown in

figure 1-3. When installing under worktops incorporating combined hobs, a

gap of at least 110 mm must be left from any side wall, as shown in figure

1. When installing in tall units, comply with the dimensions shown in figure

1-2, bearing in mind that the top/rear of the unit must have an opening 80-

90 mm deep. Screw the 4 screws A into the inside of the frame (fig. 1). For

installation under tops, make sure that the rear/bottom of the unit has an

opening similar to that shown in figure 1 (ref. B). See the instructions

supplied with the hob for the relative positioning and fixing procedures.

1 2 ... 21 22 23 24 25 26 27

Sin comentarios

Smeg APL360XC1 Manual de instrucciones Pagina 26