Smeg NCT685CHK Instrucciones de uso

Contents 3 1 INSTRUCTIONS FOR SAFE AND PROPER USE ______________________ 4 2 POSITIONING OF THE HOB ______________________________________ 6 3 EL

Instructions for the installer 12Burner Rated heating capacity Natural gas – G20 2.0 kPa Nozzle diameter 1/100 mm Reduced flowrate (W) Auxilia

Instructions for the installer 13 Burner Rated heating capacity Town gas G110 – 0.8 kPa Nozzle diameter 1/100 mm Reduced flowrate (W) Auxilia

Instructions for the installer 14 6 FINAL OPERATIONS Having carried out the above adjustments, reassemble the appliance following, backwards, th

Instructions for the installer 15 6.3 Arrangement of the burners on the hob Burners 1. Auxiliary 2. Semi rapid 3. Rapid 4. Rapid lar

Instructions for the user 16 7USINGTHEHOB Before turning on the burners, make sure that the burner rings, caps and grids have been fitted correctl

Instructions for the user 17 7.2 Practical advice for using the burners For better burner performance and minimum gas consumption, flat bottomed

Instructions for the user 18 8 CLEANING AND MAINTENANCE Before any intervention, disconnect the power supply of the appliance. 8.1 Cleaning

Instructions for the user 19 8.2.2 The cover Clean the glass or steel cover, where mounted, with warm water. Never use abrasive sponges or deterge

Cod. 914772070/B

Introduction 4 1 INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRET

Introduction 5 THE IDENTIFICATION PLATE, WITH TECHNICAL DATA, SERIAL NUMBER AND MARKING IS CLEARLY VISIBLE UNDER THE CASING. THE PLATE ON THE CASING

Instructions for the installer 6 2 POSITIONING OF THE HOB The following operation requires building and/or carpentry work so must be carried out

Instructions for the installer 7 3 ELECTRICAL CONNECTION Make sure that the voltage and capacity of the power line conform to the data shown on

Instructions for the installer 8 4 GAS CONNECTION Connection to the gas mains may be made with a rigid copper pipe or with a flexible pipe and co

Instructions for the installer 94.1 Connection to LPG Use a pressure regulator and make the connection to the tank according to the provisions of

Instructions for the installer 105 ADJUSTMENT FOR DIFFERENT TYPES OFGAS Before performing any cleaning or maintenance work, disconnect the appli

Instructions for the installer 115.2 Nozzle replacement and primary air adjustment Loosen screw A and push support B all the way. Use a double