Smeg WO-01 Manual de usuario descargar pdf (Pagina 22)

- 48 -

Press ENTER or F1:

Stop motore se in moto per … (Stop motor after …)

The following two messages concern the osmosis pump

motor condition. Set = 0 to exclude this mode; if the value

is not 0, the motor stops running after having run

continuously for the set period, then starts again.

After two seconds, the system displays:>>>>>>>>>>>>>>

Press ENTER or F1:

If the conductivity value remains below set value, no alarm

trips, otherwise an alarm displays.>>>>>>>>>>>>>>>>>>>

Press ENTER or F1:

Set number of pulses per litre for the product flow

meter.>>>>>>>>>>>>>>>>>>>>>>>>>>

Press ENTER or F1:

Set number of pulses per litre for the waste flow

meter.>>>>>>>>>>>>>>>>>>>>>>>>>>>>

Press ENTER or F1:

Set minimum production below which a fault is

reported.>>>>>>>>>>>>>>>>>>>>>>>>>>>>

1 2 ... 17 18 19 20 21 22 23

Sin comentarios

Smeg WO-01 Manual de usuario Pagina 22