Smeg WDI12C Manual de usuario

1 INTEGRATED WASHER DRYER INSTRUCTION MANUAL GB

GB 10 3.7.2 Use of the furniture door fixing template Proceed in the following way when applying the wooden panel to the washing dry

GB 11 4. On the opposite side of the f urniture door either insert closing hook “B” or screw in metal plate “C” into the upper side opp

GB 12 4. DESCRIPTION OF CONTROLS 4.1 CONTROL PANEL All the commands and controls of the appliance are assembled together on the f ron

GB 13 A Open door button Press the button to open the door. Chapter 5 – Washing in-structions – explains how the door works and how t

GB 14 G Display The display shows the following information: 1. time remaining for the sele cted programm e, gi ven in hours/mi

GB 15 M Options buttons The options that may be available on the washer dryer are shown below. Quick wash Button This button

GB 16 N Options enabled LED's These LED's light up when the relative option button is pressed and indicate that the option h

GB 17 5. WASHING INSTRUCTIONS 5.1 PREPARING THE WASHING 1. Separate the washing according to the type and colourfastness of the fabr

GB 18 5.3 PREPARING THE WASHING Where possible, save electricity by washing full loads divided by type of fabric. Introduce loose wash

GB 19 5.6 DOSING POWDER DET ERGENTS Normally dirty washing 1. Choose a programme without prewash. 2. Pour the total quantity of dete

2 GB Contents 1. The new washing system 3 2. Saf ety warnings 4 3. Installation instructions 6 4. Description of controls

GB 20 UDisplay information When the machine is switched on, the display visualises the duration (hours/minutes) and maximum spin speed

GB 21 5.11 STARTING THE WASHING PROGRAMME 1. Bef ore starting the selected programme, carefully close the door, open the water tap a

GB 22 To continue draining and spinning, press the spin select button twice. The machine resumes the cycle by draining the water and

GB 23 • For automatic wash+dry programmes, theref ore, the dry ing temperature depends on which washing pro-gramme is selected. • The

GB 24 Dry ing times depend on the spin speed: the higher the speed the lower the drying time and, consequently, the lower

GB 25 6.5 INTERRUPTING OR CHANGING THE DRYING PROGRAMME 1. To interrupt the dry ing programme, proceed as indicated in point 1 of par

GB 26 7. CLEANING AND M AINTENANCE Important – Before cleaning or servicing the machine, remove the plug from the socket. 7.1 EXT ERN

GB 27 3. Pull out the drain hose “A”. Attention: if the hose is hot it means the water is hot or boiling. Place a tray on the f loor

GB 28 8. TROUBLESHOOTING This product complies with current saf ety regulations gov erning electrical equipment. For saf ety reasons

GB 29 11 The machine does not spin The unbalanced load sensor has triggered because the washing is not unif ormly distributed inside

GB 3 1. THE NEW WASHING SYSTEM This new washer dryer is the outcome of years of research. The leading-edge design and the quality of t

GB 30 9. CONTROL PANEL SYMBOLS PROGRAMS OPTIONS OTHER SYM BOLS DRYI NG WAT ER I NCREASE FABRI C CO NDI T IO NE

PROGRAMME GUIDE - KEY TO BUTTONTemperatureMax. recommended load (kg)Prewash detergentMain wash detergentAdditive (optional)Quick washExtra RinseDrying

GB 4 2. SAFETY WARNINGS Attention! These w arnings are given for safety reasons. Please read them carefully before installing and usi

GB 5 Do not wash petrol-soaked garments in the washer dryer. Make sure there are no inflammable items (e.g.: lighters, matches, etc.) i

GB 6 3. INSTALLATION INSTRUCTIONS Important ! The appliance must be installed by a specialised technician according to current regulat

GB 7 3.3 ADDITIONAL IMPORTANT INSTALLATION INSTRUCTIONS 1. Caref ully read the installation instructions in point 3 on page 6 of the

GB 8 3.5 DRAIN CONNECTION 1. Insert the end of the drain hose into a drain pipe hav ing an internal diameter of at least 4 cm and a h

GB 9 3.7 FIT TI NG T HE F URNIT URE DO O RS Once the washer dry er has been correctly installed and commissioned, the f urniture doo