Smeg WMF16AX1 Manual de instrucciones

WASHING MACHINE INSTRUCTIONS MANUAL GB 1

GB starting from 600 rpm up to 900 rpm. H Options buttons The options that may be available on the washing machine are shown below.

GB display. To resume the washing cycle from where it left off, simply press the “Start/Pause” button again. M Start-Pause button LED

GB 5. WASHING INSTRUCTIONS 5.1 PREPARING THE WASHING 1. Separate the washing according to the type and colourfastness of the fabrics.

GB 5.3 PREPARING THE WASHING Where possible, save electricity by washing full loads divided by type of fabric. Introduce loose washing

GB 5.6 DOSING POWDER DETERGENTS Normally dirty washing 1. Choose a programme without prewash. 2. Pour the total quantity of detergent

GB Display information When the machine is switched on, the display visualises the duration (hours/minutes) and maximum spin speed envi

GB 5.11 STARTING THE WASHING PROGRAMME 1. Before starting the selected programme, carefully close the door, open the water tap and add

GB If the no-spin option was selected during the initial spin speed set up phase and the machine stops with the tub full (spin speed 0),

GB 6. CLEANING AND MAINTENANCE Important – Before cleaning or servicing the machine, remove the plug from the socket. 6.1 EXTERNAL CLE

GB 3. Pull out the drain hose “A”. Attention: if the hose is hot it means the water is hot or boiling. Place a tray on the floor and re

GB Contents 1. The new washing system 3 2. Safety warnings 4 3. Installation instructions 6 4. Description of controls 8

GB 6.6 CLEANING THE WATER INLET FILTER The machine is fitted with a filter for protecting the water inlet valves. The filter is fitted

GB 7. TROUBLESHOOTING This product complies with current safety regulations governing electrical equipment. For safety reasons, all tec

GB 11 The machine does not spin The unbalanced load sensor has triggered because the washing is not uniformly distributed inside the dr

GB 8. CONTROL PANEL SYMBOLS PROGRAMS OPTIONS OTHER SYMBOLS DRYING WATER INCREASE FABRIC CONDITIONER

PROGRAMME GUIDEProgramme guideTemperature Max. washing load (kg)Prewash detergentMain wash detergentSoftener QUICK WASHEASY IRON Description of washin

PROGRAMME TABLEOptionsProgramme Temperature - DescriptionMax. recommended washing load (kg)Prewash Wash Softener Rapid Drying possible after washingMa

GB 1. THE NEW WASHING SYSTEM This new washing machine is the outcome of years of research. The leading-edge design and the quality of t

GB 2. SAFETY WARNINGS Attention! These warnings are given for safety reasons. Please read them carefully before installing and using th

GB Do not wash petrol-soaked garments in the washing machine. Make sure there are no inflammable items (e.g.: lighters, matches, etc.) i

GB 3. INSTALLATION INSTRUCTIONS Important ! The appliance must be installed by a specialised technician according to current regulation

GB 3.3 WATER SUPPLY CONNECTION 1. Check that inlet pressure lies between the following values: 50-900kPa. For higher pressures, instal

GB 4. DESCRIPTION OF CONTROLS 4.1 CONTROL PANEL All the commands and controls of the appliance are assembled together on the front pan

GB A Open door button Press the button to open the door. Chapter 5 – Washing instructions – explains how the door works and how to use