Smeg SE2951TC2 Manual de servicio descargar pdf (Pagina 24)

Instructions for the installer

9.5 Cutting out the counter top (only on models without frame with straight

edge)

The illustrations indicate the additional cutting and milling dimensions to be used for the hole made in the

counter top if the hob is to be installed flush with the work surface.

The counter top cutting and milling dimensions are purely indicative; refer to the actual dimensions of

your glass ceramic hob before cutting.

L (mm) X (mm) Y (mm) G (mm) H (mm) A (mm) B (mm) C (mm)

600 565 490 604 519 50 min. 50 min. 750 min.

770 745 490 774 519 50 min. 50 min. 750 min.

After laying the adhesive sponge (A) on the glass

surface (see 9.4 Hob seal) and after positioning

and securing the hob, fill the edges with insulating

silicone (B) and wipe away any excess. In the event

the glass surface has to be removed, cut the

silicone using a cutter before attempting to remove

it (C).

Enough silicone must be used to create a seal between the hob and the counter top, but not so much

as to fasten the appliance. To fasten the appliance see “9.7 Fixing using brackets”.

1 2 ... 19 20 21 22 23 24 25 26 27 28

Sin comentarios

Smeg SE2951TC2 Manual de servicio Pagina 24