Smeg SE2951TC2 Manual de servicio descargar pdf (Pagina 7)

Instructions for the user

4. BEFORE FIRST USE

Before cooking for the first time, all labels and protective films applied to the inside or outside of the

appliance must be removed and the hob subsequently cleaned.

Following this, put a saucepan of water on the front hot plates and turn them on full for at least 30

minutes. After 30 minutes turn off the front hot plates and turn the rear hot plates and the central hot

plate, if present, full on. This treatment is necessary in order to get rid of the "new smell" and to

evaporate any humidity that may have accumulated during the manufacturing process. This is necessary

to ensure that the electronic circuits and the control keyboard work properly.

If the controls do not work properly after 30 minutes, it means that not all the humidity has evaporated:

leave the hot plates on until all the humidity has evaporated and then turn off the hob.

To switch on the hob, follow the instructions provided under paragraph “6. Using the hob”.

When first connecting to the mains, may be displayed. This does not mean that the hot plates are

hot, but that during factory testing the hob was switched off with residual heat active. This signal will

clear within 5 minutes.

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Sin comentarios

Smeg SE2951TC2 Manual de servicio Pagina 7