Smeg FAB32YBL Guía para resolver problemas descargar pdf (Pagina 16)

Instructions for the user

PROBLEM POSSIBLE CAUSE PROBABLE SOLUTION

Too much ice forming on back wall of

refrigerator section (layer of frost

more than 1 cm thick):

- Cooling temperature regulator

device set too high (meaning

lower temperature inside the

appliance);

- door opened often or for long

periods;

- Turn the regulator to a lower

setting (1-2) to increase the

temperature inside the appliance

slightly;

- check that the gaskets are

providing an airtight seal;

- open the door less often and for

shorter times;

- rise in atmospheric temperature

and humidity;

- do not place hot food or drinks

inside the refrigerator;

Too much ice forming in freezer - inside temperature setting

thermostat set on too low a

temperature;

- Turn the regulator to a lower

setting (1-2) to increase the

temperature inside the appliance

slightly;

- check that the gaskets are

providing an airtight seal: If they

are cracked, try to soften the

gasket by pulling it with one hand

and sliding your closed fingers

along the inside;

- open the door less often and for

shorter times;

- rise in atmospheric temperature

and humidity;

- do not place hot food or drinks

inside the freezer;

Front of cabinet hot to the touch - - the refrigerator is operating

normally. Inside the cabinet there

is a surface cooling system

designed to restrict the formation

of condensation in the area where

the door gasket closes.

Doors misaligned - - check that the refrigerator is

levelled properly, also adjusting

the two rear feet if necessary .

Check whether changing the

settings of the four feet improves

the alignment.

1 2 ... 11 12 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios

Smeg FAB32YBL Guía para resolver problemas Pagina 16

Comentarios a estos manuales

Relacionado con productos y manuales para Frigoríficos Smeg FAB32YBL